So I recently purchased an e28 525e (euro/aus version) with a manual trans. My plan was to use my existing 731 head I have on my 323i and chuck that on the 2.7 block from the 525e and convert to motronic 1.3 with the dizzy on the cam with the motronic wiring. Easy right? Well I have discovered that its a lot of money and fucking around. Originally I thought i could use the motronic ecu and harness from the 525e and swap it to me e30 but its totally different.
So I was thinking, would it be possible to use my pre existing L-Jetronic harness and ecu on the 2.7 stroker? I would have to exchange the dizzy shaft that exists on the block of my 323i to the 2.7 block but I am not sure if thats possible. This is not the end goal as L-Jetronic sucks ass and down the line I will just convert to haltech.
So I was thinking, would it be possible to use my pre existing L-Jetronic harness and ecu on the 2.7 stroker? I would have to exchange the dizzy shaft that exists on the block of my 323i to the 2.7 block but I am not sure if thats possible. This is not the end goal as L-Jetronic sucks ass and down the line I will just convert to haltech.
Comment