Announcement

Collapse
No announcement yet.

Car Wont Start! Need Help ASAP

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    #31
    Car will still start with a broken rocker. Drove my old one with one for 3 months.

    Originally posted by ROLLingKING
    i have a bronzit and plan on making it look sweet.
    Originally posted by slammin.e28
    Moral of this story?

    If you drive your e30 on stairs, you're gonna have a bad time.

    Comment


      #32
      Up
      Last edited by AsharC; 12-13-2011, 06:19 AM.


      BUY MY WHEELS! BBS E50s!!
      http://www.r3vlimited.com/board/showthread.php?t=275407

      Originally posted by Lurker27
      Any man will tell you being blown is better than being stroked.

      Comment


        #33
        Up.


        BUY MY WHEELS! BBS E50s!!
        http://www.r3vlimited.com/board/showthread.php?t=275407

        Originally posted by Lurker27
        Any man will tell you being blown is better than being stroked.

        Comment


          #34
          If you wanna check your timing belt take the oil cap and confirm the cams are spinning.

          Comment


            #35
            I replaced the belt in April, would it have gone bad that fast? or faulty belt?


            BUY MY WHEELS! BBS E50s!!
            http://www.r3vlimited.com/board/showthread.php?t=275407

            Originally posted by Lurker27
            Any man will tell you being blown is better than being stroked.

            Comment


              #36
              Bump.


              BUY MY WHEELS! BBS E50s!!
              http://www.r3vlimited.com/board/showthread.php?t=275407

              Originally posted by Lurker27
              Any man will tell you being blown is better than being stroked.

              Comment


                #37
                IF you dont knows if the cams are spinning, just crank the engine and peak through the oil fill cap for a few seconds...

                Comment


                  #38
                  Zhe cams are spinning.


                  BUY MY WHEELS! BBS E50s!!
                  http://www.r3vlimited.com/board/showthread.php?t=275407

                  Originally posted by Lurker27
                  Any man will tell you being blown is better than being stroked.

                  Comment


                    #39
                    Are the flywheel sensors really ok? Did you buy new ones or test the ohm value on them? It's a 325e right? So there are 2 in the flywheel housing. If these are dead or you just replaced them with junkyard sensors the fuel pump or DME won't get any power.

                    Comment


                      #40
                      I replaced the sensors with working ones. Still the same problem


                      BUY MY WHEELS! BBS E50s!!
                      http://www.r3vlimited.com/board/showthread.php?t=275407

                      Originally posted by Lurker27
                      Any man will tell you being blown is better than being stroked.

                      Comment


                        #41
                        Bump.


                        BUY MY WHEELS! BBS E50s!!
                        http://www.r3vlimited.com/board/showthread.php?t=275407

                        Originally posted by Lurker27
                        Any man will tell you being blown is better than being stroked.

                        Comment


                          #42
                          "Well did you check the CPS"
                          "yup, its fine"
                          "bump"
                          "bump"
                          "bump"
                          "Well did you see if the pump runs while starting"
                          "yup"
                          "bump"
                          Did you check to see if the coil..."
                          "Yup still won't"
                          "bump"
                          "bump"
                          "bump"

                          I just find this conversation funny.

                          OK OP how about this, why don't you tell us what you haven't done, checked, or replaced yet.

                          That way we can narrow down the problems that we have and haven't covered otherwise we might just give up and the thread will be unfinished. Try making a list of whats not been done so far.

                          Comment


                            #43
                            Have you tried talking dirty to it? Sometimes it helps get your e30 in the mood.
                            sigpic

                            Comment


                              #44
                              i have this exact same problem on my 1984 325e shitty business. the amount of oil its leaking is crazy. time to pull it out and get to work i guess
                              my build thread:

                              http://www.r3vlimited.com/board/showthread.php?t=231612

                              Comment


                                #45
                                Mine too. Idk if it oil or trans fluid. Its leaking in the back of the bay.


                                BUY MY WHEELS! BBS E50s!!
                                http://www.r3vlimited.com/board/showthread.php?t=275407

                                Originally posted by Lurker27
                                Any man will tell you being blown is better than being stroked.

                                Comment

                                Working...
                                X