Announcement

Collapse
No announcement yet.

Urgent help needed m20 head bolts

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    Urgent help needed m20 head bolts

    so im swapping to the torx style

    1.shoud i COMPLETE each bolt before movin on (22ft lbs-90-90)
    or just 22 then 90 then come back

    2. the top left hex bolt ame out COVERED in oil and while re installing the torx it feels like there is fluid in there, I think this because while finger threading in the new bolt i will feel resistance then it goes away as if there was fluid being compressed then seeping up the bolt....help?>

    #2
    Originally posted by bastianshaw View Post
    so im swapping to the torx style

    1.shoud i COMPLETE each bolt before movin on (22ft lbs-90-90)
    or just 22 then 90 then come back

    2. the top left hex bolt ame out COVERED in oil and while re installing the torx it feels like there is fluid in there, I think this because while finger threading in the new bolt i will feel resistance then it goes away as if there was fluid being compressed then seeping up the bolt....help?>
    Are you just swapping head bolts or have you removed the head ?

    The holes MUST BE DRY or you will crack your block from the hydraulic pressure
    Last edited by jeffnhiscars; 01-12-2013, 08:43 PM.
    Seat Shocks....I have passed the baton to John Christy from Ninestitch. Email John or Garrett at ninestitch1@gmail.com

    https://www.r3vlimited.com/board/sho...86#post4944786
    Alice the Time Capsule
    http://www.r3vlimited.com/board/showthread.php?t=360504
    87 Zinno Cabrio barn find 98k and still smells like a barn. Build thread http://www.r3vlimited.com/board/show...20#post3455220

    Comment


      #3
      ok got em in i just pulled out a bolt and it and another one was covered in oil and the other 12 were fine so it was kinda like wtf

      Comment


        #4
        When just replacing the bolts, you do each one all the way. The threads in the block really need to chased and they must be clean of any contaminates. A regular thread chasing tap isn't long enough, so you weld an extension on.
        The car makes it possible, but the driver makes it happen.
        Jim Levie, Huntsville, AL

        Comment


          #5
          You can spray brake cleaner down in them and blow them out(watch your eyes) or you can find long stemmed qtip like swabs to clean out the oil. Definitely clean them out or you can crack the block.
          My M20 Frankenbuild(s)
          4 Sale - Fully Built TurnKey Megasquirt Plug and Play EMS

          Comment


            #6
            If you replace the headbolts only, do you follow the removal sequence (from end) or tightening sequence (from center). Should it be done when the engine is cold or at operating temperature?

            Comment


              #7
              I would do it cold and doesn't really matter the order as everything is settled and clamped but cant hurt to follow the normal torque sequence and torque each one fully as you go.
              My M20 Frankenbuild(s)
              4 Sale - Fully Built TurnKey Megasquirt Plug and Play EMS

              Comment

              Working...
              X