how much for this machine work?

[kickinindian]

i am getting an m52b28 crank for my 2.8l stroker and i was wondering how much do you guys think roughly i should expect to have the counterweights bobbed and balanced and cleaned up?

[Noshow20x96]

hey bud, im doing the samething, I just got my M52b28 crank and m20b27 rods, I got a quote from a respectable machine shop for about $800, that's cutting down the counterweights, balancing, blueprinting and cutting down the block .25mm

that's pretty much the ball park of doing it

[redlightpete]

This job cost me around $75 for the crank counterweight cutting, and another $150 for balancing.

[MR 325]

$800 is an astronomical price.

I don't know the exact prices off hand but we can have it done a lot cheaper here!

[kickinindian]

$800 is an astronomical price.

I don't know the exact prices off hand but we can have it done a lot cheaper here!

Lol I thought so too!

Sent from my VS930 4G using Tapatalk

[Cabriolet]

$800 is an astronomical price.

I don't know the exact prices off hand but we can have it done a lot cheaper here!

I got a quote from a respectable machine shop for about $800, that's cutting down the counterweights, balancing, blueprinting and cutting down the block .25mm

cutting down the crank is usually $200-300 here. then add on cutting the block and my guy would charge me $300. but still $800 seems over priced.

[Noshow20x96]

Ok. I can talk to my guy a see. Like I said. It's a rough estimate. I didn't get it done yet.

[TobyB]

blueprinting

That might be a few hundred right there. It's pretty time- consuming.

Figure $150- 200 for weights, $200 for balance, $100 for a block cut, and that leaves $300 for
blueprinting. If that's the whole engine, that's a fair price.

It all depends on what's getting done. Is the shop factoring in new fasteners in the
blueprint? That'd do it right there...

t