Announcement

Collapse
No announcement yet.

Engine buck/jerk/stalling

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    Engine buck/jerk/stalling

    The Car:
    1987 325is with the stock motor, 5sp

    Issue
    About a month ago, I would experience jerking/bucking and my RPM would drop to 0 while moving in gear, and would stall completely(lights such as brake line, ABS would come on) when I went into neutral. The car would also stall sometimes at a red light or a stop sign. As the RPM would drop the economy gauge will increase from 0- ~40, I'm not sure if that has an significance. Just today, the car bucked once and the CEL was a solid RED.



    What I've done
    -I found oil in the TPS so I cleaned it out along with the ICV, throttle body, CPS and AFM.
    -The car ran great for about two weeks until I found a rip in the intake boot, which I replaced and the car ran fine again for another ~2 weeks.
    - I've recently replaced the Coolant temp. sensor(blue), fuel pump and ECU main relay.
    -I've replaced the spark plugs, and o2 sensor about ~3k miles ago.
    -I've only done the carb cleaner vacuum test which yielded no irregularities


    HELP

    Just looking for your thoughts. Would a vacuum leak cause an irregular idle at all times? My car idles just fine more times than not, nice and steady. I bought a DURALAST coolant temp sensor, could it be a faulty unit?

    #2
    C171 connector?
    Current:
    '88 325ic Silver 5sp
    '17 Subaru Outback 3.6R

    Past:
    '14 Rav4 EV (with tons of torque!)
    '06 325i Black 5sp
    '02 S4 Avant Black 6sp
    '00 Boxster Silver 5sp
    '98 New Bettle Yellow 5sp

    Comment


      #3
      A vacuum leak is usually constantly leaking. If it's only occasional, then usually the leak isn't bad enough to cause stalling, just a lumpy idle.

      You said you cleaned the CPS, did you test it?
      AWD > RWD

      Comment


        #4
        Originally posted by mazzo View Post
        C171 connector?
        Could you possibly mean the c101? the big 20 pin connector? What about it ?

        Originally posted by Kershaw View Post
        A vacuum leak is usually constantly leaking. If it's only occasional, then usually the leak isn't bad enough to cause stalling, just a lumpy idle.

        You said you cleaned the CPS, did you test it?
        No, I actually have not because I do not own a multimeter but I cleaned a whole mess of grime off of it.

        Comment


          #5
          Sorry, I meant c101. Could there be fluid leak into the connector?
          Current:
          '88 325ic Silver 5sp
          '17 Subaru Outback 3.6R

          Past:
          '14 Rav4 EV (with tons of torque!)
          '06 325i Black 5sp
          '02 S4 Avant Black 6sp
          '00 Boxster Silver 5sp
          '98 New Bettle Yellow 5sp

          Comment


            #6
            Originally posted by kazzman View Post
            No, I actually have not because I do not own a multimeter but I cleaned a whole mess of grime off of it.
            If you're going to work on e30s, you need one. They're like $5.99 at harbor freight. The cheap ones work just fine.
            AWD > RWD

            Comment


              #7
              Fusible link in battery cable. Had the same problem with my 87.

              Comment

              Working...
              X