Announcement

Collapse
No announcement yet.

Injector connector pins?

Collapse
X
Collapse
 
  • Page of 1
  • Filter
  • Time
  • Show
Clear All
new posts
Previous template Next
    #1

    Injector connector pins?

    So while replacing the PCV hose, I accidentally pulled the wires out of the #4 injector connector.

    It's an AMP connector (I imagine most/all are)

    However, the Bosch EV1 style connectors on the market are typically Delphi. All I need are the pins (and some instruction on how to remove them). I would rather not replace the connector, or even worse--splice in a pigtail.

    Anyone have the part number or supplier for new pins?





    Last edited by The Dark Side of Will; 03-31-2016, 03:39 AM.
    Tags: None
    #2
    Been there done that.

    Bosch 1 287 013 003.

    You're welcome.
    Your resource to do-it-yourself and interesting bmw and e30 stuff: www.rtsauto.com

    Your resource to tools and tips: www.rtstools.com

    Comment

      #3
      You can get junior timer etc. pins from Amp on mouser.com.
      Build thread

      Bimmerlabs

      Comment

        #4
        Originally posted by noid View Post
        Been there done that.

        Bosch 1 287 013 003.

        You're welcome.
        I figured someone here had.
        Thanks!

        ETA: oh, that's the entire connector kit. Useful as I can't get the pins out of the original. Now, if only I could find gray to match...


        Originally posted by nando View Post
        You can get junior timer etc. pins from Amp on mouser.com.
        Ballenger is a decent source for a lot of these parts I and they even list the junior power timer pins, but I wasn't sure that's what these are.

        ETA: I'll need the entire kit if I can't get the pins to release
        Last edited by The Dark Side of Will; 03-31-2016, 05:16 AM.

        Comment

          #5
          you can get the 2-pin connectors & boots too.

          Wow those kits are expensive. you can get all those same parts from an electronics shop such as mouser. the pins are pennies each, the connectors/boots aren't even close to that much either.
          Build thread

          Bimmerlabs

          Comment

            #6
            CarQuest had the kit, so I was raped to the tune of $11.

            Now... which wire goes into which cavity in the connector? The pins are numbered 1 & 2 on the connector body, but the ETM (at least the one that I have) doesn't show pin numbers on the diagram.

            ETA: I just pulled the boots back on a couple of others and looked. The red/wht (+12 supply) is on the left when looking at the connector from the injector side with the wire loop at the top.

            I tried to ring out the wires from one connector to the one I replaced, but the signal looped back through the DME and both pins each showed continuity to both pins on the other. :fishslap:
            Last edited by The Dark Side of Will; 04-01-2016, 08:10 PM.

            Comment

            Previous template Next
            Working...
            X