Eagle 135mm Forged H-Beam Connecting Rods?

[whodwho]

@ Keith, what do those weights include? bolts/bearings/pins wise?

Would be a bare rod if I weighed them but those were from old notes and could have been gathered from other's posts.

I am out of town but back in a couple days, I will pull some rods I have out and throw them on a scale

I have a few sets I can weigh
M20 130
M20 135
M52 135
Eagle 135
M50tu 140
Pauter 140
CXRacing 130
CXRacing 135

[digger]

All with bolts excluding shells

molnar 135mm H-beam 500g
m20 135mm 636g
m20 130mm 606g
Alpina B3 3.3 135mm 540g
ZRP I-beam 564g

[whodwho]

@ Keith, what do those weights include? bolts/bearings/pins wise?

All with bolts excluding shells

molnar 135mm H-beam 500g
m20 135mm 636g
m20 130mm 606g
Alpina B3 3.3 135mm 540g
ZRP I-beam 564g

I weighed them all tonight with bolts(could vary?) no shells to stay consistent, let me know if more details needed of any of them

M20 130 - 601.5g
M20 135 - 633.8g
M52 135 - 579.2g
Eagle 135 - 549.5g
M50tu 140 - 646.6g
Pauter 140 - 517.3g
CXRacing 130 - 515.6g
CXRacing 135 - 549.5g

Just for S&G
VAC S54 - 516.7

[digger]

i dont put too much emphasis on mass, its way over emphasised for a lowish rpm engine. i didnt choose the lightest rod out there.

its interesting the pauter 135mm rods are heavier than the 140mm

http://pauter.com/parts/rods/bmw/

its good they come with BE and SE mass though for a 6cyl its less relevant

as an FYI the ZRP i have are 399g and 165g which also calculates out that the BE is about 70% of the mass like the pauter

[ForcedFirebird]

Dang Keith. You weren't kidding about a hoarding pile.