Ok, i know its a stupid question but I am stuck, or just hoping its not a head gasket issue. I have no visible leaks anywhere. New water pump and the front of the engine is dry. There is no fog happening inside or wet floor boards, so i dont think its a heater core. And I have no white smoke in the mornings or at any time, at all. WTF? Oh, and before we go farther its a e34 with an m20. So any ideas that are not a head gasket?
Where is my coolant going?
Collapse
X
-
and freeze plugs are good. no signs of coolant leaking anywhere on block.Comment
-
^ good advice
1986 325es (69k) Garage Queen Buy It Now 10k;1986 325es (track rat) 2.7i How-To & 1.1/1.3Motronic UpGrade
1991 318is (daily driver) 1991 318is M42 Maintenance How-To;1989 325i (parts car)Comment
-
I hope that is it, but its been a month since I bled the system and it has taken over a gallon or so. I appreciate all the help and dont mean to just shoot all your answers down. I just cant figure it out.Comment
-
If you have gone through that much coolant, the problem isn't the result of a less than perfect bleed.
The first thing to do is to pressure test the cooling system.If there's a leak you'll see the fluid or you'll know there's a leak because the system won't hold pressure. If the system passes a pressure test you have to consider the possibility that there's a small head gasket leak that is pressurizing the cooling system to the point that the cap lifts, which will dump coolant overboard via the vent line. That may only happen at speed and will leave no trace as to where the coolant went. A simple check for this is to chalk the inside of the vent line and see if the chalk is still there the next time you have to add coolant.The car makes it possible, but the driver makes it happen.
Jim Levie, Huntsville, ALComment
-
checkthe connection of the lines closet to the block under the manifold. You will have a hard time locating the leak, if its evaporting and covered in grease.Comment
-
You can sometimes find a leak by driving the car and getting it fully warmed up. Shut off the car and leave the hood closed for 5 minutes. After the 5 minutes, open the hood and look everywhere with a strong light.
The reason for this procedure is that the system temperatures and pressures are highest after shutdown, and the leaks will show up then. If you wait any longer, the leaks might evaporate and leave no trace.
Good luck!Comment
Comment