Hello. I bought this 90% finished M335i (M325i with 3.5 from E32). It was running a little 240 (or is it 242?) from a pfl 318i with a m20 clutch. I did some skids and now the clutch is broken.
Anyway, I've picked up all the stuff from an M30 powered E28, including a 260-01302-91 gearbox that is only about 2cm shorter than a 260 from a E30 325i. It's got the bigger yolk on the output shaft so I can't use any E30 driveshaft.
Just wondering if any of you experts know of any driveshafts with the bigger yolk on the tranny end that will bolt straight in? I'm trying to avoid getting custom work done on an E30 driveshaft, cause that kind of work is really quite expensive. I know I could just swap the yolks over, but I can't help but think BMW must have used that bigger yolk for a reason!
A quick picture to make it official:
Cheers!
Max.
Anyway, I've picked up all the stuff from an M30 powered E28, including a 260-01302-91 gearbox that is only about 2cm shorter than a 260 from a E30 325i. It's got the bigger yolk on the output shaft so I can't use any E30 driveshaft.
Just wondering if any of you experts know of any driveshafts with the bigger yolk on the tranny end that will bolt straight in? I'm trying to avoid getting custom work done on an E30 driveshaft, cause that kind of work is really quite expensive. I know I could just swap the yolks over, but I can't help but think BMW must have used that bigger yolk for a reason!
A quick picture to make it official:
Cheers!
Max.
Comment