Announcement

Collapse
No announcement yet.

Pin Outs! i need them

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    #16
    thank you guys, im about to go outside and take a look so i'll check back with wire color and such

    Need Illustration or Design work? www.robbiebyerly.com

    Comment


      #17
      ok im confused about this power to my ECU issue can some one explain it a little more??? all i need is the ECu to get power for this thing to start up!

      Need Illustration or Design work? www.robbiebyerly.com

      Comment


        #18
        use the radio 12v acc.
        84' 318i m30b35 swapped!

        Comment


          #19
          and connect it to what?

          Need Illustration or Design work? www.robbiebyerly.com

          Comment


            #20
            Originally posted by RickSloan View Post
            ok im confused about this power to my ECU issue can some one explain it a little more??? all i need is the ECu to get power for this thing to start up!
            In M20 wiring, the ECU gets power through the 3-poled connector in glovebox.
            In M30 wiring, the ECU gets power through the 63-poled big connector which connects to ECU box.

            So all you need to do, is to run a jumper wire from 3-poled connector in glovebox, to the round connector where car wiring set connects to engine wiring set. Correct pins can be found on www.e30.de schematics.
            - E34 M5 (x 2) -
            - E30 V8 Cabrio "Kylpyamme" -
            - Alpina D10 Touring #33/94 -

            +
            - E46 318i Touring -
            - Toyota Hiace 4wd -

            Comment

            Working...
            X