Here's the issue, my temp gauge does not work at all when the car is started, it just stays in the "blue" and will not budge. However, when the ignition is turned to acc. the gauge will go all the way into the red and stay there until the car is started.
This all started after doing the mess under the intake mod. Before this, the gauge worked as it should. I am thinking that maybe I forgot to connect a ground, or something got bumped.
Before anyone asks, the plugs are not switched for the two temperature sensors on the head, I have made sure of it. I should also add that both of those sensors are brand new, thinking that they were the culprit.
I really have no idea where to go from here. I checked all of the wiring and it looks just fine, no exposed wires or potential locations for shorts.
If anyone has any ideas, throw them out there, I am sick of chasing this stupid problem! At this point, I am thinking about just buying an aftermarket gauge, but I would really like to avoid it.
This all started after doing the mess under the intake mod. Before this, the gauge worked as it should. I am thinking that maybe I forgot to connect a ground, or something got bumped.
Before anyone asks, the plugs are not switched for the two temperature sensors on the head, I have made sure of it. I should also add that both of those sensors are brand new, thinking that they were the culprit.
I really have no idea where to go from here. I checked all of the wiring and it looks just fine, no exposed wires or potential locations for shorts.
If anyone has any ideas, throw them out there, I am sick of chasing this stupid problem! At this point, I am thinking about just buying an aftermarket gauge, but I would really like to avoid it.
Comment