The car won't even go into 1,2,3,4,5,R, it looks to be in neutral and won't go into any gear. But the car is in reverse if you turn on the car. I am most certain it is not inside the transmission. I went under the car but I couldn't figure out what's wrong. :(
Stuck in reverse! Help!
Collapse
X
-
-
Comment
-
But you need to determine if it is a shift linkage issue or a transmission issue. Do as Jim had stated.
Sent from my Galaxy Nexus using Tapatalk 2Comment
-
My transmission doesn't move into any gear! It just wiggles around in neutral but the tranny thinks it's in reverse. -.-Comment
-
You still haven't answered our questions....
Sent from my Galaxy Nexus using Tapatalk 2Comment
-
How am I supposed to answer your question if I can't go to 1,2,3,4,5,R? If I can't go to and see if the selector rod moves that attaches to the transmission.Comment
-
Well if you can't get someone to move the shifter while you go under the car to see if anything is moving/broken how are we supposed to help you?
Sent from my Galaxy Nexus using Tapatalk 2Comment
-
i have a stupid question, do you have a clutch stop that slipped out of adjustment can not let the clutch disengage88 325is Five SpeedLachssilberComment
-
Sent from my Galaxy Nexus using Tapatalk 2Comment
-
I HAD a clutch stop but I took it out when it got stuck in reverse thinking maybe that might have been the problem.
And dude that sucks. My car broke down about two miles from my house and for a second I was debating on driving it home in reverse.Comment
-
When G260's go bad this is what happenes. Most cases they were dry.
1. jack the car up and support it on jack stands and then let the car run in reverse to warm up the tranny. (give it some revs and make it whine) Cut it off when it gets good and warm
2. remove the front half of the drive shaft
3. remove the shift selector rod
4. Open the filler screw and stick your finger in it to feel for fluid. If you don't feel shit then open the drain and look for metal shavings.
5. if its dry or has nasty ass fluid, go buy some redline ATF and fill that sucker up.
6. Trun the car back on but make sure the output flange of the tranny is clear of obstruction. Let the tranny warm up again reving it and circulating the fluid around. This will lubricate the stuck reverse gear/sychro and hopefully allow you to knock it out of gear. Turn it off when it gets good and warm
7. take a hammer and give the selector bolt a good lesson or two and this should knock it out of reverse.
Reassemble and you should be good to drive around in all of your forward gears. I've had luck enough to use reverse again but if I were you I would never put the car in reverse till I got another tranny.
also, to get into gear with a bad synchro I would have to shut the car off and then put it in gear. start it back up and go.
***cliff notes, buy a new transmission and install it.Comment
Comment