I did a stock 325i swap with a remanu rack from rackdoctor. I had it aligned afterwards. I noticed now I have a wider turning radius. Could this be from the rack or tie rods?
-
Renting my rear wheel bearing tool kit. SIR
http://i25.photobucket.com/albums/c5...ps6debf0b0.jpg
Your signature picture has been removed since it contained the Photobucket "upgrade your account" image. -
Wider one way? Or both directions? -
Assuming you did not change anything else and depending on where you put the subframe spacers (think bump steer) the rack should not effect radius at all. Either way an alignment should bring it back to spec. The only other variable I can think of is if you used a 95 M3 rack which is progressive and I believe all the M3 racks have the stops in a different place due to wider tires.
Rich (the Rack Dr) should be able to clear that up for you.Seat Shocks....I have passed the baton to John Christy from Ninestitch. Email John or Garrett at ninestitch1@gmail.com
https://www.r3vlimited.com/board/sho...86#post4944786
Alice the Time Capsule
http://www.r3vlimited.com/board/showthread.php?t=360504
87 Zinno Cabrio barn find 98k and still smells like a barn. Build thread http://www.r3vlimited.com/board/show...20#post3455220Comment
Comment