I hate wiring, Help me 4x4 my IX! No Spark, FML
Collapse
X
-
Just because you have continuity to ground does not mean you have good ground. You'd have to measure voltage drop under load to determine that. If your coil is not getting batt positive, its prob a 90% chance the ignition switch is the problem, just based on that. Pin 18 is hot at all times, pin 27 is the dme turn on lead and splits to the coil AFTER the ignition switch. Go buy a NEW ignition switch. -
Checked and swapped Main Relay. No change. Still not getting power to the coil.
Pin 27 is still dead. We have ground on all the pins listed in the first post. IIRC, 2,14,19,2...Leave a comment:
-
This sounds like you're looking at the flashing "check" light for the overhead check panel.
Check engine light should be solid in the bottom left corner of the cluster, right around the foglight symbol.
EDIT: Nevermind, everyone else already said that lol.
But just throwing it out there, the relays should all be fine. The harness and relays were taken from my car, which ran flawlessly up until I wrecked it. I suck at electrical work, though, so I can't really help diagnose.Leave a comment:
-
if i get my paycheck today i'll be more than happy to drive out there and try to hammer this out with you.Leave a comment:
-
e30>me
Be back on after a bit guys. Thanks for the suggestions so far!Leave a comment:
-
yeah, that's referencing the check panel above the rearview mirror. assuming none of the other lights are on, the brake light should go away the first time you hit the brake pedal, and take the CHECK light with it. Also pushing the CHECK button on the panel will stop the flashing as well.Leave a comment:
-
I'm pretty sure it was a flashing CHECK light. I thought it was odd that it didn't say ENGINE.Leave a comment:
-
the CEL will actually say CHECK ENGINE, and it is not the light that flashes saying CHECK.Leave a comment:
-
Hmmm, now I'm not sure. I'll drive over there in a bit and take a look.Leave a comment:
-
-
is your check engine light coming on with the key in run? If not, the DME either isnt getting power or is brokenLeave a comment:
-
yes
just cause the relay clicks doesn't mean it's working. Heck, even if it's working doesn't mean it's working. Mine was recently turning off randomly. Took a couple weeks to figure that one out...Leave a comment:

Leave a comment: