I hate wiring, Help me 4x4 my IX! No Spark, FML

Collapse
X
 
  • Time
  • Show
Clear All
new posts

  • dark89e30
    replied
    Just because you have continuity to ground does not mean you have good ground. You'd have to measure voltage drop under load to determine that. If your coil is not getting batt positive, its prob a 90% chance the ignition switch is the problem, just based on that. Pin 18 is hot at all times, pin 27 is the dme turn on lead and splits to the coil AFTER the ignition switch. Go buy a NEW ignition switch.

    Leave a comment:


  • JakeP
    replied
    Checked and swapped Main Relay. No change. Still not getting power to the coil.
    Pin 27 is still dead. We have ground on all the pins listed in the first post. IIRC, 2,14,19,2...

    Leave a comment:


  • E30Nova
    replied
    Originally posted by JakeP
    Yes, check engine light is flashing with the key on.
    This sounds like you're looking at the flashing "check" light for the overhead check panel.

    Check engine light should be solid in the bottom left corner of the cluster, right around the foglight symbol.

    EDIT: Nevermind, everyone else already said that lol.

    But just throwing it out there, the relays should all be fine. The harness and relays were taken from my car, which ran flawlessly up until I wrecked it. I suck at electrical work, though, so I can't really help diagnose.

    Leave a comment:


  • accident
    replied
    if i get my paycheck today i'll be more than happy to drive out there and try to hammer this out with you.

    Leave a comment:


  • JakeP
    replied
    e30>me

    Be back on after a bit guys. Thanks for the suggestions so far!

    Leave a comment:


  • accident
    replied
    yeah, that's referencing the check panel above the rearview mirror. assuming none of the other lights are on, the brake light should go away the first time you hit the brake pedal, and take the CHECK light with it. Also pushing the CHECK button on the panel will stop the flashing as well.

    Leave a comment:


  • JakeP
    replied
    I'm pretty sure it was a flashing CHECK light. I thought it was odd that it didn't say ENGINE.

    Leave a comment:


  • accident
    replied
    the CEL will actually say CHECK ENGINE, and it is not the light that flashes saying CHECK.

    Leave a comment:


  • JakeP
    replied
    Hmmm, now I'm not sure. I'll drive over there in a bit and take a look.

    Leave a comment:


  • nando
    replied
    Originally posted by dark89e30
    Do you have a check engine light with the key turned to run?
    the check engine light is flashing, or the check light is flashing? the check engine light should be solid.

    Leave a comment:


  • dark89e30
    replied
    Flashing not good.

    Leave a comment:


  • dark89e30
    replied
    Do you have a check engine light with the key turned to run?

    Leave a comment:


  • JakeP
    replied
    Yes, check engine light is flashing with the key on.

    Leave a comment:


  • accident
    replied
    is your check engine light coming on with the key in run? If not, the DME either isnt getting power or is broken

    Leave a comment:


  • nando
    replied
    yes

    just cause the relay clicks doesn't mean it's working. Heck, even if it's working doesn't mean it's working. Mine was recently turning off randomly. Took a couple weeks to figure that one out...

    Leave a comment:

Working...