wiring question...

[nick526]

My ABS and brake lining lights are on due to some torn up wires under the car. The connector for the right rear pad wear sensor came out of the holder on the backing plate and got torn out along with a piece of the harness.

My bentley manual doesn't include any info on this part of the wiring and an hour or so of searching hasn't done me much good. Does anyone know where these three wires are supposed to go? It seems that two wires go to the sensor but what about the third?

TIA

[nick526]

Anyone?

[nomansland92]

On my other car i just tied the two wires together on the car side and that will complete the circuit and turn the light off. Well this was for my 944 not the e30 but i would imagine its the same not sure about the 3rd cause i don't have abs

[riceh8r]

best i can tell from my diagrams...blue/white and green/yellow are your wear indicator wires. left hand rear speed detector is green. hope this helps.

[nick526]

sweet, i'll have to get under there and do a little digging. Those two bright ass lights on my cluster are getting annoying haha.