If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I searched-ish.. Now that i've swapped out clutch and brake pedals from an 88 325i/vert the brake light switch won't make contact with the brake pedal. I've tried to adjust it to no avail. How do I make it blend?
Solution is:
Remove brake pedal and adjust clevis on brake booster (counter clockwise) while counter holding booster shaft until pedal hits brake switch (reinstall after 2-3 turns to test)
I seem to remember a different bracket and brake light switch from my brother swap. Its a 90 going from auto to manual. Also saved the harness plug from the donor car because the switch plug was different.
Comment