My brake lining light is on.
The sensors looked okay (plastic is all in-tact), but I replaced them anyways... light still on.
Had a cut wire for the wiring in the driver's wheel well, and I had that fixed by soldering in new wires... light still on.
Tried shorting the wiring by placing a wire into the connectors... light still on.
For now I have pulled the lightbulb out of the cluster, but I'd like to figure this one out.
How would I go about tracing the brake lining wires and find out where the short is?
The sensors looked okay (plastic is all in-tact), but I replaced them anyways... light still on.
Had a cut wire for the wiring in the driver's wheel well, and I had that fixed by soldering in new wires... light still on.
Tried shorting the wiring by placing a wire into the connectors... light still on.
For now I have pulled the lightbulb out of the cluster, but I'd like to figure this one out.
How would I go about tracing the brake lining wires and find out where the short is?
Comment