I did a E36 5 lug swap, E36 M3 front arms/knuckles/struts/TreeHouseCAB and rear is Z3 I6 hubs and rotors.
I was planning on running Style 5s 17"s RC090s but realized too late the fitment is too wide (low of an offset ET20). I have a mix of RS 16" pieces and was going to try and make up a set and find some lips/barrels. I have the 16" 5x120 faces but was hoping I can get somebody with fitment experience with the swap I have. I know I need about an ET30-40.
Was thinking 7.5" barrels and 1" lips in the rear to give me 9"s and 6.5 barrels/1" lips in the front.
Any wider of lip and it will lower my offset too much.
Barrels and lips are expensive so I hope I can make this work, any feedback?
I was planning on running Style 5s 17"s RC090s but realized too late the fitment is too wide (low of an offset ET20). I have a mix of RS 16" pieces and was going to try and make up a set and find some lips/barrels. I have the 16" 5x120 faces but was hoping I can get somebody with fitment experience with the swap I have. I know I need about an ET30-40.
Was thinking 7.5" barrels and 1" lips in the rear to give me 9"s and 6.5 barrels/1" lips in the front.
Any wider of lip and it will lower my offset too much.
Barrels and lips are expensive so I hope I can make this work, any feedback?
Comment