Man, I really want to get these for my car.... but 200 bucks? idk.. I need some reassurance lol. Is it considerably better than just some oe m3 rubbers?
-
Current Collection: 1990 325is // 1987 325i Vert // 2003 525i 5spd // 1985 380SL // 1992 Ranger 5spd // 2005 Avalanche // 2024 Honda Grom SP // 2024 Yamaha XSR700 // 2024 Jeep Gladiator Rubicon
-
I think they are....and they cost more for the e46. Ordering some for the wife's car in a few weeks.Originally posted by blunttechComment
-
Love mine.
225/45/16 no issues
Sent from my Galaxy Nexus using Tapatalk 2Comment
-
I have offset control arm bushings available:
•• Powersteering Deletes • M20 Motor & Trans Mounts • 24V swap mounts • UHMW Offset CABs ••
•• Rear Subframe Bushings • RTABs • Facebook ••
Comment
-
anyone got photos of the THR in there car?Comment
-
I'll get one tomorrow
Sent from my Galaxy Nexus using Tapatalk 2Comment
-
Sent from my Galaxy Nexus using Tapatalk 2Comment
-
essential for header clearance in 24v e30 swaps.
my ride was harsh but I had all urethane bushings in my 5lug carOriginally posted by bluntComment
-
i like these. the overall weight of these must be much lower then anything else on the market.
as well as the added room and the obviously more rigidity they give. i think im going to have to go with a set of these.
thanks FLG for the picComment
-
My review is they are ultra harsh.
It's a race only part. Sold them after a week.
Bought a set from reading the good reviews on how they're not harsh at all ect. HA
Running over a penny felt like hitting a curb. Hey, felt great though as far as performance.
Comment
-
i think im used to harsh haha. i just did a 8hour run in my car with 440f and 675r spring rates on billys. haha. the knocks cracked the welds on my rear muffler.... so thats gone haha. i welcome these haha.Comment
-
Treehouse Control Arms
I am the original OEM for these Treehouse Control Arms. We were manufacturing these for Treehouse and when they went under, we were left with a surplus of inventory. We have these on the shelf, ready to go (pending final QC inspection). They are unpainted/non powder-coated 6061 aluminum or SS steel (depending on the model). We can sell these considerably cheaper from what they were on the market before. Prices start at $110 and up depending on the model.
Comment
Comment