Crazy bumps steer with new upgrades

[ejnight]

Installed HR race springs Billy Sports and a 95 M3 rack with PS delete. any suggestions?

[Philo]

What's the problem?

[ejnight]

What's the problem?

the bump steer. it just about pulls the wheel out of my hand.

[gearheadE30]

you had it aligned, right?

were the spacers above or below the rack when you installed it?

[BigD]

The wheel getting pulled out of your hands is not bump steer. Undo your PS delete or eat more cornflakes.

[ejnight]

you had it aligned, right? yes

were the spacers above or below the rack when you installed it?

above the rack.

[ejnight]

The wheel getting pulled out of your hands is not bump steer. Undo your PS delete or eat more cornflakes.

So thats a little bit of an exaggeration but it does pull hard.

[e304me]

i think above is the right place to have them but you might want to check on that

[e304me]

and did you get alignment? toe out would cause that

[Philo]

How much PS fluid did you leave in your rack? Also, what method did you use; alum block, ps line loop, 2 holes?

If there is too much fluid, it will be stiff as hell and jerk back because there is no room for the fluid to travel. On my PS delete, I left about an ounce of fluid in there.

[Mot]

I had a similar problem with my ps delete. It was the same problem, too much fluid no where to go.

[ejnight]

How much PS fluid did you leave in your rack? Also, what method did you use; alum block, ps line loop, 2 holes?

If there is too much fluid, it will be stiff as hell and jerk back because there is no room for the fluid to travel. On my PS delete, I left about an ounce of fluid in there.

I used a alum block and filled the rack. turning it one way then the other. and topped it off.

[Philo]

I would try to let some fluid out to see if that helps the problem. The only reason the fluid is needed, is to lubricate the rack. A very slight amount will do, as the ATF fluid spreads easily.

[ejnight]

I would try to let some fluid out to see if that helps the problem. The only reason the fluid is needed, is to lubricate the rack. A very slight amount will do, as the ATF fluid spreads easily.

will do thanks all.

[Philo]

Let us know how it goes.