what's your ride height?

[deeze30]

Just want to get some opinions out there and how you guys measure your height from fronts and rears. In the process of adjusting my coils and just cant get it tuned in. I know if differes from suspensions and spring rates but just numbers of what you guys ride? Is it just pretty much a "eyeball it" kinda thang?

[NC318e30]

A lot of guys measure from either the ground to center of fender or center of wheel to fender.

[Garageaholic]

If you're doing coilovers, you measure the amount of exposed threads.

If you just have springs/shocks, then it is what it is. Other than that, I don't understand the question.

[IRON-E]

Center of the fender to the ground (23inches) for DD or (19-21inches) to be retarted slammed for shows on 17s.

[Cletonius]

I'm right around 12" from center of the hub to the fender; as tall as it goes for usage as a DD.

I use a set of scales to help get my measurements right also.

[deeze30]

All these would be for all 4 corners? Unless you want some rake goin on also then its a different story.

[Cletonius]

Yes, my measurements all worked out the same. I have all my adjusters set about as tall as they'll go. One of my steering rack bolts is stuck so I don't have a skid plate on at the moment; I'd like to go lower.

[deeze30]

Yes, my measurements all worked out the same. I have all my adjusters set about as tall as they'll go. One of my steering rack bolts is stuck so I don't have a skid plate on at the moment; I'd like to go lower.

Looking good man. Your height is about the same as mines right now. Plannin to go lower since I got the raceskid plate on there right now its just the company I bought my jom kit from left out my spanner wrenches so I can't adjust my coils at the moment unless I disassemble strut towers

[campbellj25]

For alignment specs and/or ride height adjustments BMW has us measure from the bottom lip of the wheel to the bottom center of the fender for comparing side to side.

[Cletonius]

Looking good man. Your height is about the same as mines right now. Plannin to go lower since I got the raceskid plate on there right now its just the company I bought my jom kit from left out my spanner wrenches so I can't adjust my coils at the moment unless I disassemble strut towers

Thanks, I'm really happy with it overall. Can you use a strap wrench or lift the car and turn them by hand?

[deeze30]

Thanks, I'm really happy with it overall. Can you use a strap wrench or lift the car and turn them by hand?

No its too tight. I got my wrenches but still cant figure this thing out