15x10 Rear questions

[OrangeFiero]

I have accepted the challenge of trying to fit a 15x10 in the back of my e30. As i understand after some searching, if i go with 6" back spacing, i will be flush and safe of any rubbing in the inner lip. Will the inner barrel of the wheel fit? I was hoping to not poke too much and if they are not flush enough, just use spacers to fine tune fitment. Pics would help.

[Robotin]

you have to run like a -10

[OrangeFiero]

you have to run like a -10

What is that in back spacing? And i thought i needed to run a higher positive et or they would poke like mad.

[Pootis]

I thought the max amount of back spacing you can run in the back is 4.5? Correct me if I'm wrong

[OrangeFiero]

http://www.stanceworks.com/forums/sh...ad.php?t=10611
Oscar on this forum says hes running 5.5BS on his 15x10 but it is an early model, ive got a late... dont know if different.

[OrangeFiero]

http://www.r3vlimited.com/board/show...=204023&page=2

On r3v: half way down page 2, white325is says hes running a 6" back spacing too.

[series88]

http://www.r3vlimited.com/board/showthread.php?t=219821

Check with this guy. :)

[bmwguy325is]

If you click the link for my car in my sig I run 15x10s
The wheels on my car a pretty much a zero offset. I run a 5mm spacer all around but that is so I can clear in the front and I want everything square.
With the spacer the wheel sticks out about 2 inches or so.
If that helps.....

[wakdog]

Im running 15x10 +15 BBS RS on the rear of my car, and there is about 2mm of clearance from the rear trailing arm and the inner barrel. Anything higher offset than +15 is going to hit....

Here is a pic of it with temporary 205/50R15s (going to go 225/45 when i get an engine back in the car....)

[OrangeFiero]

Thanks for the help guys! I think i know that i need to now.