Does anyone know what's involved in this finish? Powder then polish? Or polish then mask off and powder? I'm interested in the finish in the face...
Attached Files
-
sigpic
Current:
92 325ic Mtech 770
99’ 528it
Past:
02’ 325it - 88' 735i - 88' 325ic - 89' 325is - 85' 325e
90' 535i - 95' 530i - 03' 530i - 88' 325ic -
Powder then polish. Afterwards, hopefully some sort of clear (Clear PC wouldn't hold well on polished surface) or ceramic. -
I did a small stint of working in a powder coating shop years ago, and when we did re-work the cured powder coating was insanely hard to remove, it is a very hard coating. Wonder if you can get the powder coaters to remove the powder from the face before they cure it. Might have to think up a cleaver way to do this so as not to disturb the coating in the crevices.
Or just paint it rather than powder coating.Comment
Comment