My e30 in the Traction bed

[diegom6]

Sicne I pulled off the engine for the stroekr conversion, I'm approaching to fix the twsited front end of myc ar.

I bought the car with out, or at elast the first 3 or 4 months didn't notice it.

I think got worst with the pass of the years and thanks to the fully hole sin my roads and stiff suspension ended like this.

The car doesn't look like it had in the pass a strong crash or front collison other than just a simple crash in the low section where you see is all messed up. But hte chasis "arms" are fine and no signs of been repaired before.


See how twisted it is! :neutral:









Note that the EYE of the base of the traction bed, doesn't align up with the little hole where the bumper tight in the arm chasis.















Diego

[nando]

wow, that's pretty crazy. your poor car, hopefully you can get it back in one peice again. maybe your crazy turbo motor twisted the chassis with all that torque? :P

btw, are you going to turbo your stroker or just go N/A?

[diegom6]

wow, that's pretty crazy. your poor car, hopefully you can get it back in one peice again. maybe your crazy turbo motor twisted the chassis with all that torque? :P

btw, are you going to turbo your stroker or just go N/A?

it will look and get back the messures from facotry at the end! You will see.

Yes, I already ordered Wiseco Custom Forged Pistons for my 3.0L Turbo combo. :D

[Ryan Stewart]

man Id had to get my car onto one of those and find out how far out of spec my shit is. After 2 years and a solid beating the last 4 Id think shits starting to sag or something, it feels so soft compared to new cars.

[diegom6]

Maybe could be a a idea in your head maybe not, sometimes the car just doesn't be the smae and other still are OK . Depends how twsited or how hard was the crash/twist.

I may reinforce some points to be sure, not sure yet.

[diegom6]

UPDATE:


Some more shots, just chekcing the messures from the tower shocks and rest of the front, right now is stright! :D









As you can see in these pics, the needle doesn't align up with the bolt in the fender. Right now it's already aligned :D

[Digitalwave]

That's amazing. Hope it comes out well.