If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I want to paint my brake ducts trim black but these little green clips holding them in place are being stubborn. It'll look dumb if I break 'em and don't have brake ducts so how do we get them off? I've tried everything I can
They are a pain but they just pop off, try a combination of needle nose pliers, wire cutters, and a small flat head. If you don't mangle them you can reuse them, if you mangle them you can get new ones from Blunt, but then the new ones are harder to put on then the old ones were to get off.
Originally posted by b3albakii
the head was okey .. and in a good mood
no i didnt over heat it so much
Quit being a waffleswaffleswaffleswaffleswaffles and just get them out. There's a good chance you'll break them, but they are dirt cheap. I'm not positive, but I would think you will survive without brake ducts for a couple of days.
those things just slides off the brake ducts.
i used a rubber mallet and hit the fasteners from underneath and it popped right out.
a panel pry tool could help too
Your signature picture has been removed since it contained the Photobucket "upgrade your account" image.
--------------------------------- 89 E30 S52
--------------------------------- Transaction Feedback.
Comment