If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Announcement
Collapse
No announcement yet.
Its going to be one of those winters... whatcha plannin?
Oil pan gasket, control arms, THR CABs, Poly engine/tranny mounts, then maybe rear subframe/trailing arm bushings and then center braided lines. Within the next month will be some small interior/exterior bits.
Mine's sitting in storage already, but i plan on redoing the interior completely (new carpet/door cards etc) before it gets pulled out in the spring. I'll probably make a thread for it. I started some body work on it too. I've only driven the car 52 miles in ~3 months
1989 Bronzit 325ia- Sold
1986 Diamondschwarz Grey Market 325i Sport Mtech 1- Parted out
1988 Delphin 327i- Sold
1995 Cosmos M3- Current
Keeping it under a cover in my nice warm garage. But for projects?
Pull my rear bumper and repair the seams in the sections that had to be cut to fit.
Spacers for the rear wheels, maybe small ones in the front.
Get the small section of my driver's seat bolster that's coming unstitched repaired.
Repaint my Rieger lip and get my sideskirts painted and installed.
Make a new splitter for the Rieger lip.
Paint my brake calipers silver so they don't look like hunks of 50 year old cast iron.
And if I'm lucky and I get one soon enough, start prepping for my engine swap.
Complete Respray, new headliner for the hardtop, get everything nice and tight so I can sell this bitch when the sun comes out again! then buy a 325 coupe.....or a 2002......
Hopefully an audio overhaul with modern head unit mounted in the glove box, 10" sub, 4 new speakers. I'd like to get my front seats redone but might have to settle for just the drivers at the moment. Install the remote locks, rebuilt brakes, assemble the trunk and get all of those parts out of there, get the shift linkage rebuilt (or a z4 shifter). Not ready to touch the engine yet.
Comment