E30 How To Article / Write up.

[DCColegrove]

If I was to illustrate and write up something...


What should it be about?

[DSP74]

flaring fenders for big autox tires, rear subframe removal and complete rear bushing swap, diff rebuild with ramp angles modified, header install/dyno time, manual window conversion.............

[DCColegrove]

flaring fenders for big autox tires, rear subframe removal and complete rear bushing swap, diff rebuild with ramp angles modified, header install/dyno time, manual window conversion.............

You forgot to add... Drivers sphincter pucker factor telemetry to the list.

lets try something little first...

[bimmer_E30]

i am gonna do, how to wash ur e30. hahahaha

[kenika65]

Simple, make a full maintenance how to. I will be making one soon for the M42.

It will include gaskets, seals, breaks, belts and a few bushings.

It will teach detail and mechanics.

[Fidhle007]

Simple, make a full maintenance how to. I will be making one soon for the M42.

It will include gaskets, seals, breaks, belts and a few bushings.

It will teach detail and mechanics.

[Nick325is]

Simple, make a full maintenance how to. I will be making one soon for the M42.

It will include gaskets, seals, breaks, belts and a few bushings.

It will teach detail and mechanics.

Hope it doesn't teach how to break things..

[Fidhle007]

Simple, make a full maintenance how to. I will be making one soon for the M42.

It will include gaskets, seals, breaks, belts and a few bushings.

It will teach detail and mechanics.

Do a how to on rebuilding a Ford motor with nothing but a can of spray paint.

[kronus]

Thread derail in 5 posts! Hodamn!

Shifter rebuild guide would be helpful. I'm researching it right now and all I get is "go under the car and replace everything between the hole in the tranny tunnel and the tranny selector rod.

[318isbmw]

I'd do something like doing a brake job and putting in braided lines or something of that sort.

[318isbmw]

Thread derail in 5 posts! Hodamn!

Shifter rebuild guide would be helpful. I'm researching it right now and all I get is "go under the car and replace everything between the hole in the tranny tunnel and the tranny selector rod.

Honestly when you look under there, all it is is a circlip which you slide out and then you can pop it loose w/ 2 screwdrivers from the top and it will come out. Very simple. And if you do the actual shift linkage that's a circlip at the other end and a nut is all to get it all out. Very simple. check understeer.com for a full writeup w/ pics.

[kronus]

Thanks, that site was helpful.

I might as well take some photos of my own when I do this...

[DSP74]

You forgot to add... Drivers sphincter pucker factor telemetry to the list.

lets try something little first...

I was just messin with ya.

Most people could care less about anything on that list....cept' maybe the header install/dyno run

[z31maniac]

I also want to see the ebay/IE header dyno run.

A rear subframe complete refresh would be nice, subframe mounts, trailing arms, wheel bearings.

[homegrone30]

Keyless entry install I havent really found one that makes me want to attempt it anymore, If I do try it I will make a write up mabey even go as far as remote start.