If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
It was a block of wood. possible 2x4, but looked thicker. It covered over half of my lane. Almost missed it but clipped it. Wouldnt have been to bad i suppose, but i was speeding too much. These rims though seem pretty legit as in being strong. my suspensions pretty stiff, and im pretty good and avoiding pot holes but sometimes they are unavoidable and i have it a couple bad ones. esp while out of town. The wheels have stayed strait to my suprize. the only the has the bend is this one and i assume its only the outer lip, No vibration with it being on the left front from 0-90mph. Ive been dieing to get some 16x8.
I was up above it, Now I'm down in it ~ Entropy - A Build thread. @Zakspeed_US
this happened to me with my Contour reps. I decided to source a used, cheap oem contour, and turned around and sold them as a set. Its easier to sell a set of 4 then find a home for 3 singles. Plus its one shipment for the set, or 3 trips to the pack and ship for the singles.
in conclusion, source a single from Ari over at eurostop.
I can tell you I had a lead on a set a while back in great condition with great tires for 500, 600 shipped.
I would give you 400. You've been down here before, I think you met my friend mark with the red 91 last time you were down, so we could meet in the middle or something...
Comment