After finishing the oil return and feed, it looks like my oil return was welded at the wrong angle. Is there any salvaging this short of pulling the pan and rewelding a new bung on?
looks like the oil will be fighting gravity. My plan is to put a funnel on the top of the line and drizzle some oil down the hose with the drain plug out to see if it drains. Thoughts?
I'm in denial because I don't want to take the pan off, lining the scraper, and two gaskets was hard enough on the engine stand. Please help
EDIT: I didnt take a picture of it but the oil return line has a 1.5 feet of straight drop before this. maybe I'm being paranoid but I figure its better safe to ask
looks like the oil will be fighting gravity. My plan is to put a funnel on the top of the line and drizzle some oil down the hose with the drain plug out to see if it drains. Thoughts?
I'm in denial because I don't want to take the pan off, lining the scraper, and two gaskets was hard enough on the engine stand. Please help
EDIT: I didnt take a picture of it but the oil return line has a 1.5 feet of straight drop before this. maybe I'm being paranoid but I figure its better safe to ask
Comment