My 88 SETA

[It's Soda Not Pop]

I ordered a set of wheels from Fitment Industries back on March 1st. I thought it would take a lot longer for them to come in. But they have shipped already and they look like they will be here on Friday 11th. After they come in and I install them I will post pictures.
The wheels I ended up getting are a set of ESM 002's 16x8 20et. I was going to buy a set of Apex ARC-8's. But to be honest I didn't want to run 17's. Plus I'm eventually going to run a set of Works or have my bottle caps re-barreled.......or both. These ESM's look good and have a classic look without being uber expensive. Plus my tire choice just got way bigger by going to these versus the 14" bottle caps.

[It's Soda Not Pop]

And here is what the CATuned looks like on the car.

[It's Soda Not Pop]

Awhile back I had the unfortunate pleasure of being rear-ended. It wasn't too horrible. But it did crack my rear bumper. Which sucked because it was in good condition. It just need to be painted. Either way I replaced it with a unit from CATuned. It's not OE but it fits pretty good and it didn't break the bank.

[It's Soda Not Pop]

This must be a blast to drive! Any plans for wheels/tires?

Man I love driving it. I'm leaning toward Apex ARC-8 wheels.

[Slowgan]

This must be a blast to drive! Any plans for wheels/tires?

[It's Soda Not Pop]

Found some pictures from back in 2017 when I was doing the head swap and subframe reinforcement.
The subframe ended up being warped and I had undo everything. I just order some weld in plates and reinforced my old one instead.
The head luckily went on without a hitch.

[It's Soda Not Pop]

https://youtu.be/wC6j_MtgW34

https://youtu.be/rvkIHLfGTxU

[It's Soda Not Pop]

So this is list of mods that I have done on my E30. Pretty standard 2.7i build. Eventually I'm going 2.8/2.9, up compression, and ITB's.
(I also have a maf conversion by SSSquid tuning as well)