Wow, really nice clean up man!
Accuracy Auto 91' 318i build.
Collapse
X
-
Mtech1 v8 build thread - https://www.r3vlimited.com/board/sho...d.php?t=413205
OEM v8 manual chip or dme - https://www.r3vlimited.com/board/sho....php?p=4938827 -
Nice, that carpet was fuckin' disgusting!1990 Islandgrun 535iM Sedan
Euro lights + trim | Eibach/Bilstein | BBS RC090 17x8 | EAT Chip | Port + Polish | IE 284 Cam | Built valvetrain

Comment
-
Wowsers. I thought my 12 pine needles stuck in mine where bad. Soda explosion or just a straight up Cola fight?
What'd you use to dye the carpets exactly?
Good luck! It looks like you're up to it.Need a part? PM me.
Get your Bass on. Luke's r3v Boxes are here: http://www.r3vlimited.com/board/showthread.php?t=198123Comment
-
nice car, sedans happen to be perfect to drive on the daily haha.. mines been so far.. i just have horribel taste of parts :(
looks nice man.. keep the updates comingComment
-
Hey Joe, thanks a lot for the Helicoil size. It saved me some time searching!
Well Im back from Germany and I have a lot of motivation. So I figured "Fuck, its not raining yet. I'll get some work done on this thing before 2010."
Cleaned off the seat rails for re-installation, about a dollar in change came out of them. And now they slide properly without binding. Hmm go figure.
Before:

After:

Installed:

Next It was time to play with the paint while I had the weather on my side. This sucked because my back is still hurt from my accident. So it took me all day yesterday to do the exterior, usually takes me about 5 hours when I'm 100%.
Basically the summery of the process was, rewash the car removing all pine needles. Remove the pitch and sap. Claybar the car. Then begin the cutting process.
One side of the hood cut:

Hood fully cut. Notice the difference in color on the fender:

Trunk cut:

All tops done. You can see the old color on the side:

While I was cutting I was also finishing the door trim. Before and after:

Door trim installed and all Cut, polished and Waxed. Except for the cowl, A-pillers and bumpers/valances. (as she sits right now):

Breaks over. Back outside, I'm finishing the interior today.Comment
-
clean car.
wish my m42 had that low miles...
1991 BMW 318i (Old Shell RIP, Now Being Re-shelled & Reborn)
1983 Peugeot 505 STI
1992 Volvo 240 Wagon
2009 Toyota 4Runner SR5 Sport 4WDComment
-
I would have hit the seat rails with some black spray paint. It'll make the interior look a lot newer.
Comment
-
True, but I don't really care too much as they are almost completely hidden when installed.
Today I swaped the shitty, broken, blue and green pioneer deck out for a nice Sony CDX-R3000 I had laying around.
I didn't get to finish the interior yesterday because my room mate broke our linen closet door. I spent the rest of the day building a duplicate.
So im aiming for today. Then suspension tomorrow. Fingers crossed.Comment
-
wow, very nice. That's really low miles, and the interior looks pretty dang good. Nice work with that carpet :)Comment
-
Comment
-
Thanks guys!
Cabin - I actually used plasti-dip. Its my first time using it. Just like everyone says, it is very good.
Just make sure its warm, other wise is comes out in big blobs and you have to do it again. I just ran it under hot water for 5 minutes and then it came out in a mist.Comment






Comment