If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Did some cluster work. The gears just went bad, so I replaced them with the garagistic ones. My GF painted my needles with her nail polish ;) Turned out awesome! I also put in some black cluster rings.
Finally figured out the tig. This is 1/8" aluminum on a powerpro 205. If you know how to mig, tig will be a lot easier to learn. These are my beads after my first hour or so of tig'ing
There are so many settings on this machine it's overwhelming, lol. I still have a lot of room for improvement.... Suggestions?
Leave a comment: