14 years - 1991 325ix, Stroker/5-Speed (N52 swap?)

[Eric535]

pics of finished gauge cluster?

[James Crivellone]

Love all the old photos of my mtech (pre mtech). Good times, damn we have had these cars for a long time

[nando]

they are similar, but not quite the same. the bearings differ by .05mm but I know lots of people who use the rears in the front of an ix, they're also half the price!

[ForcedFirebird]

Yeah, I couldn't believe you got them for that. After seeing the damaged threads in the other ones, I looked around and they were far more at most places. They appear to be the same as RWD rear hubs, but didn't measure anything to see.

[nando]

actually what I paid for the new front hubs was damn cheap! :(

[ForcedFirebird]

At least the labor wasn't killer ;)

Still a lot of dough in parts. I never realized how expensive ix parts are until we restored the rear of one. Guibos are crazy expensive, sub-frame bushings etc - anything ix specific. My jaw dropped when looking at the prices for new hubs.

[FredK]

I'm trading some labor to have it built by a "pro" :)

Yes, it certainly would be worth it to get it set up by a "pro", because IIRC a 3.38 is most commonly from an E36, so to set it up in an E30 case will require shimming, measurement, adjustment, and verification of gear contact pattern.

It'll be a great ratio!

[MR 325]

it's kind of scary how much money I have into them, but damnit, I'm so sick of bottoming out and bouncing around!

This is kind of what I was thinking while looking at the pics... :D

[nando]

it's kind of scary how much money I have into them, but damnit, I'm so sick of bottoming out and bouncing around!

Maybe now I can take my wife in the car without grimacing over every little bump :p

[MR 325]

Very nice!

[nando]

finally struts are pretty much done :)





They're still at WOT tech in Florida. When get my grubby romneys on them, I'll update the 2012 post. Once they're on the car, I'll have to decide if I want to further drop my front spring rates (I'm thinking 400-450#), which also depends if I can make the E46 swaybar work. Hopefully I can significantly increase my comfort level!

[nando]

Lol, that little knick has been there for years, it's barely even qualified as "surface rust".

It's a driver, not a show car :)

[iXguido]

Fix that rust asap! ;)

[giantkeeper]

My mind is blown - impressive work!

[nando]

represent! :)



still waiting on the complete suspension. working on the "other" stuff too, just nothing to reallly show at the moment..