Transforming my Alpine 325is

[Turbotalon92]

Thanks guys. A sensor testing I will go!

[mRodiek]

ICV, AFM, IAT sensor, O2 sensor? sensors galore!

This.

& big brakes yes, but painting stock calipers just kinda shows how small they are lol but you like it, thats all that counts

[Turbotalon92]

Damn you guys are going to make me buy big brakes or turbofans before I can sort out my idle issue! :)

[Turbotalon92]

Rolled the front fenders today. Was quite easy actually.

[PNWDan]

Looking good. I'm partial to the early Alpine Is though lol.

[PNWDan]

So got the injectors in, much nicer power and responsiveness, old injectors had some serious carbon build up on the middle cylinder banks, much less to each end.

I have done about everything I can think off for on off load stumble and am scratching my head as it is still there. M20, new fuel filter, new injectors, new distr., wires and plugs, tested coolant sensor, and not sure where to dig next? It stumbles at idle, cold or hot, drives great under load, cold start is quick and sharp, hot start is a bit slower but not anything crazy long when turning over.

Thoughs?

Do your plug wires have the pickup wire on them? If they are E not I plug wires they won't have the timing pick up and it will stumble off idle.


Also check the AFM moves freely and is clean.

[Turbotalon92]

So a few updates, mostly maintenance stuff

New fuel pump, my little girl helped me install.



Pulled the seats for a good cleaning and did some leather conditioner

[Turbotalon92]

Also did some fresh rotors and pads all around and adjusted the height on rear coilovers to eliminate the rake.