Check panel renovation

[butters]

I'm about to drop $300 on a clean 2-gauge VDO setup for the ashtray, granted that includes senders and wire harness I would think that you can look at what people pay for gauges and consider that as the point to beat/match. I'm sure you can get a lot of good information in that space.

[Cletonius]

This would be sweet. Do you think you could still cycle the display with the turn signal stalk?

[ninjaotter]

This would be sweet. Do you think you could still cycle the display with the turn signal stalk?

If somebody wanted to donate an appropriate stalk and cabling, I'm sure I can get it to work. Otherwise I was just going to leave it up the installer on where to put the button.

[Cletonius]

If somebody wanted to donate an appropriate stalk and cabling, I'm sure I can get it to work. Otherwise I was just going to leave it up the installer on where to put the button.

Let me check my parts stash....

[slammin.e28]

Oh man, this is good!

Def in for updates!

[ButtJuice]

I have a turn signal stalk from an early model. Pm me for a pic or whatever, I don't need it.

[ninjaotter]

It would also help to have as much of the cable that attaches to it intact. But yeah, that shouldn't be too hard at all.

Is there a difference between early and late? Anyone that wants to donate one, PM me and I'll send along my address.

[dogsbark26]

Sounds interesting. In for pricing/functionality.

[LagunaVert]

Provocative! Compass and Voltage would be killer. After 6 months of looking at an open hole there I contemplated making a semi permanent Ipod mount bc its a perfect fit. Seemed like a waste with no Ipod connective head unit tho...

[JCarp90]

Um, yeah. Count me in.

[pandaboo911]

george graves should get in on this

[pilotskillse30]

In for results

[ninjaotter]

I've made a LOT of progress. I'll take some pictures when I get back into my workshop.

I am afraid that this will be ABSURDLY expensive in a small batch. It would also require a sizable down payment prior to production. So basically, there are huge obstacles to these finding their way into anyone elses hands.

Sadly, this may well be a one off. Short of someone wanting to go into business with me and deciding to invest a few thousand dollars in production equipment.

[kingston]

Would a Group Buy doing a small run make it more feasible? In other words, if you sell 10 of these at once, would that lower the cost per unit in any meaningful way?

[berlow94]

Definitely in! If its under $500 a piece then ill take two if that helps!