I was tuning it, then blew a brake line. Not fun.
-
1997 540i/6 - stock
1985 325 - M50NV - Getrag 250 - 2.79 LSD - MS2/e -LC-1 - 750cc injectors - Blunttech Manifold - HX35 - AEM UEGO
1991 318i - M50NV - Getrag 240 - 4.10 open - e36 rack - Smileys - 55w 5000k HIDs -
Put this in.
IG: @Baye30
FRONT VALENCE IS ZENDER!!! STOP FILLING MY PM BOX PPL!!!Comment
-
Drove it out of state, over 1000 miles away from all my tools, and removed the front suspension in a friends garage to install new springs.
Ich gehöre nicht zur Baader-Meinhof Gruppe
Originally posted by Top Gear
Every time you buy a car with DSC/ESC, Jesus kills a baby seal. With a kitten.
Comment
-
New coil, crankcase breather hose, fuel lines to the tank and filter/fuel pump, plus I fixed an intake leak at the idle control motor. Runs much better now :DJust a little project im working on
- http://www.lse30.com -Comment
-
Put a roof rack on today.
From The Land Of Sky Blue Waters.
Originally posted by lamboComment
-
s4.10-->s3.73Transaction Feedback: -click here
[e30: '91 318is coupe|brilliantrot||e36: '98 318ti|fern green|California top|M-Tech]
[URL="http://www.r3vlimited.com/board/showthread.php?t=300453"]Comment
-
valve adjustment and fixed some problems with the valve cover-FREEDOM- is cruisin at 80, windows down and listening to the perfect song-thinking "this is it"
-The Beauty in the Tragedy-
MECHANIC SMASH!!- (you all know you do it)
Got Drop?? ;-)
Originally posted by JinormusJComment
-
New plugs, oil, thermostat, gaskets, cluster = DONE
Got my Apexi S-AFC installed in dashComment
-
Drove it to work. For the FIRST time.Slicktop City!Comment
-
Test fitted the new brakes. 345x28 e46 m3 csl rotor with evo9 caliper. Fits perfect in the 17 :)
Comment
-
^sweet!!
On my way to pic her up from the shop...
5-speed tranny swap, lightweight flywheel, brakes, headers and exhaust!
Can't wait!Comment
-
New distributor cap and rotor. After 3 fucking owners and 25 years NO ONE had changed the damn spark wires. I was lucky that only one had a hole, but I sprang for a full loom. Also having a shop do the rear axles.sigpic
-----
Zinno 87 325iSComment
-
Did you follow a specific DIY for the cap and rotor. I intend to do mine in the next day or two.17 Range Rover Sport SVR
14 Q5 TDI S-Line
...on the hunt for another E30.Comment
-
I was having the timing belt replaced at a shop, and they noticed the poor condition of the cap and rotor. Because it was exposed for the timing belt repair, it was no extra labor cost to have it done, so I had them do the replacement.sigpic
-----
Zinno 87 325iSComment
-
My first timing belt job! I'm pleased to say my valves didn't bend!!!
I also got to install my new valve cover
Comment
Comment