What did you do to your E30 today?

[Cyrix2k]

I was tuning it, then blew a brake line. Not fun.

[golde30]

Put this in.

[u3b3rg33k]

Drove it out of state, over 1000 miles away from all my tools, and removed the front suspension in a friends garage to install new springs.

[Madhatter]

New coil, crankcase breather hose, fuel lines to the tank and filter/fuel pump, plus I fixed an intake leak at the idle control motor. Runs much better now :D

[KamakaziX]

Put a roof rack on today.

[Brilliantrot 318is]

s4.10-->s3.73

[CHIF8008]

valve adjustment and fixed some problems with the valve cover

[sayed ali]

New plugs, oil, thermostat, gaskets, cluster = DONE

Got my Apexi S-AFC installed in dash

[ldsbeaker]

Drove it to work. For the FIRST time.

[twism]

Test fitted the new brakes. 345x28 e46 m3 csl rotor with evo9 caliper. Fits perfect in the 17 :)

[cbouchez]

^sweet!!

On my way to pic her up from the shop...

5-speed tranny swap, lightweight flywheel, brakes, headers and exhaust!

Can't wait!

[Rose E30]

New distributor cap and rotor. After 3 fucking owners and 25 years NO ONE had changed the damn spark wires. I was lucky that only one had a hole, but I sprang for a full loom. Also having a shop do the rear axles.

[bmoores]

Did you follow a specific DIY for the cap and rotor. I intend to do mine in the next day or two.

[Rose E30]

I was having the timing belt replaced at a shop, and they noticed the poor condition of the cap and rotor. Because it was exposed for the timing belt repair, it was no extra labor cost to have it done, so I had them do the replacement.

[davey101]

My first timing belt job! I'm pleased to say my valves didn't bend!!!



I also got to install my new valve cover