If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I got some work done tonight, not much but some.
I ripped everything out that was in the way of the engine bay getting painted. I still got to pull the brake booster and move the ABS pump out of the way so that area can get painted as well.
I wanted to clean the engine bay up a little since it was getting all this fancy work done to it.
I cut a hole under the driver side hood slider and ran all the engine wires through it. I have a rubber boot that will slip over the wires and fit into that hole. Thats one of the reasons it is as big as it is.
Any ways enough with the talking and on to the photos.
Thats all I have for now people.
Its going to get painted this week and I should have it back next weekend.
I will post a few updates as progress is made.
one seemed to have a clunking to it when I put them in. BUT DAMN so much better for the ride home...
I hope to make it down there before the snow flys. I dont see it happening.
pm sent BTW.
I would say it reminds me more of NASCAR but I like it. Can you let me in on the plate? I've been trying to figure it out for 5 minutes, but I just got back from a class on freefall analysis and my head hurts.
"Life is hard...it's a lot harder if you're stupid."
Lets make it a date...I still need so pile up a few parts. I have a few laying around.
I have just been lazy since it got cold. :(
I will give ya a call tomorrow.
Comment