SoCal General Chat

[turge]

Morning r3v. Voted.

On a side note anyone know a chick that owns a convertible bluish green colored 2002ti?

This chick drove by me on the 101 in Encinitas the other day while I was parking at Juanita's.

Sent from my XT907 using Tapatalk 2

[ToPLeSS(e30)FeinD]

It has a new (castro installed) timing belt, so what else can i look at? crank position sensor?

CPS!!!!!!! But this time I'm super cereal. Been in that exact position before. Took a week and 4 brains to figure it out.

[mcr_driver]

Anyone willing to lend a hand and help me find out? I'm kind of stranded joyfully...

[ToPLeSS(e30)FeinD]

Brother, where art thou?

[Herr Faust Schinken]

well i voted for the first time today

[mcskibadee1]

Has anyone ever purchased a roll of laminex? I am looking to cover a couple cars headlights and fog lights. They seem much cheaper than sheets but is that because they are all rolled up and don't apply smoothly? Am I smarter to just go with the sheets?

[ninety4e36]

Has anyone ever purchased a roll of laminex? I am looking to cover a couple cars headlights and fog lights. They seem much cheaper than sheets but is that because they are all rolled up and don't apply smoothly? Am I smarter to just go with the sheets?

I had both clear laminx and smoked laminx precut on my headlights and i love them. super easy to work with if you need to get around corners (need heat gun of course) and its pretty thick.

[mcr_driver]

Brother, where art thou?

probably too far but in east los angeles 90023

[mcskibadee1]

Thanks, Ya I like the precut stuff but was just wondering how the rolls are? I think a heat gun and laying it out flat for a couple days would do the trick.

[JFarhanbod]

anyone know how to tell if an inner tie rod end is bad without it being on the car?

[einstein57]

If its limp with the weight of the outer rod on it then it aint gravy

[Ism20craze30]

South bay is leaving this Krispy Kreme location at 6 sharp
1199 West Artesia Boulevard
Gardena CA 90248
United States

[ak-]

Selling a new never used TRM oil distribution block fitting

$25

http://www.racersmarket.net/index.php?page=shop.product_details&product_id=34&option=com_virtuemart&Itemid=93&vmcchk=1&Itemid=93

[semaj4712]

Anybody have a KW Coilover tool??

[dvck]

Castrolls