NOR-CAL General Chat.

[rob&e30]

need those skirts just sent email out! omfg I would craeam for those skirts on my early!

[e30vert]

I managed to cut and splice and sauder in a new connector and about 12 inches of wiring. It's been fine since yesterday took it to work. Car feels good. All the fuses are fine. My wiring was not clipped in before so it might have pinched. I talked to Igor from Catuned and he told e they get old and corrode after a while I guess it happens lol (early model bs)

Corrosion of the insulation would allow the wires to potentially touch and that would short them out and cause a melting of the insulation as well. So that is very well possible.

Pick and Pull should have the MAF at some point depending on their e30 selection. You can check inventory on their site but I usually just browse the lot when I want to determine if there is anything worthwhile.

Ive opened my MAF myself but not to mod . To Powder and then needed to seal up the top afterwards.

[e30vert]

Off to So Cal to eat good food , see great sites, and be pampered by family for my B Day.


Will be in Redondo, Malibu, Huntington, The Valley, West Hills ,all the F over the place.

[Cabriolet]

Bruce, have fun and be safe

[Steven]

trying to bleed the cooling system on the new 325, but it is over heating. I did the timing belt, tensioner, water pump and thermostat if that helps any. I have the front jacked up a fair amount and I got it to the half way point and floored it to 5000 rpm, but it is still over heating. Also it will not stop bubbling from the radiator cap. Me and my dad are completely lost.

[Steven]

trying to bleed the cooling system on the new 325, but it is over heating. I did the timing belt, tensioner, water pump and thermostat if that helps any. I have the front jacked up a fair amount and I got it to the half way point and floored it to 5000 rpm, but it is still over heating. Also it will not stop bubbling from the radiator cap. Me and my dad are completely lost.

I guess a better way to put it, is that it wont bleed. Like it just continues to bubble no matter what we do, then eventually overheat.

[Thizzelle]

fucking automatics the first day I had it thought I was fucked because car wouldn't start back up, sat there for a minute or 2 then saw O not in park. FUCK. i seriously sit there for a few seconds everytime trying to figure out why my car won't start still not use to it. All I have ever had are manuals LOL.

[Thizzelle]

I guess a better way to put it, is that it wont bleed. Like it just continues to bubble no matter what we do, then eventually overheat.

jack up front, turn heater core on full heat. No need to rev engine just let it idle. let bleed till it looks like most bubble are out. Done.

if you can't jack park on steep hill.
also 318 you use a bleed plug on radiator.
325 you use bleed plug on thermostat housing

coolant goes everywhere

[Steven]

yeah sorry guys just called up Eric and he walked me through everything. Hopefully I can get it running nice..

[Pantless Spency]

Hehe good luck Steevie weevie

[Cabriolet]

fucking automatics

when are we doing the swap?

[Steven]

Hehe good luck Steevie weevie

Hmmm...

[Pantless Spency]

Haha :)

[Steven]

My sig ;)

[whaaac]

found a remus muffler at picknpull! woo!