I want to go back to stock sway bars for various reasons. I have a set of ST sways on my car now, 22mm front and 19mm rear, as well as a full set of new rear mount hardware/links/bushings. You will probably want to order new front bushings, but I will include the old ones and the shells.
What I want is very specific, not terribly difficult to get, but specific.
Front bar:
Stock 20mm front bar (found on coupes and sedans). NOT the 21mm cabrio bar.
Rear bar:
Stock 14.5mm bar, which was stock on the iX and was an M-Tech option on a lot of 325 models. The basic stock bar is 12mm, which I am not interested in.
So, if you have these let me know. I want to try to make the trade before Saturday so that I can install the bars while I have the subframe and diff out as part of my suspension overhaul. I have the ST bars off of my car now and ready to go. If you want to do the trade, I need you to be certain of what you have, and I recommend measuring the bars in a few locations with calipers if you aren't sure (because I WILL bring calipers with me if we meet up). This is a great deal for anyone looking to beef up their sway bars since this setup is $360 at Turner and all I want in exchange are your two stock bars, no links or other stuff.
My bars are in fine condition. The front is a bit scraped on the bottom from a decade of driveways and road debris, but it is just surface scratches. Do be aware that I HIGHLY recommend reinforcing all 4 rear mount points. The trailing arms should have reinforcing plates welded on because they will see a lot more stress, and you really really really should look into a Turner or AKG reinforcement bracket for the chassis mount points (the ones that bolt in through the trunk are fine). I had a chassis mount point rip out on me a few years back and I had to weld it back on. I am not including reinforcement brackets in this trade.
So, PM me if you are in the SF Bay Area (I am down in Santa Clara) and think you can have the parts I want by Friday. I know that this is last minute and oddly specific, but it is what it is.
What I want is very specific, not terribly difficult to get, but specific.
Front bar:
Stock 20mm front bar (found on coupes and sedans). NOT the 21mm cabrio bar.
Rear bar:
Stock 14.5mm bar, which was stock on the iX and was an M-Tech option on a lot of 325 models. The basic stock bar is 12mm, which I am not interested in.
So, if you have these let me know. I want to try to make the trade before Saturday so that I can install the bars while I have the subframe and diff out as part of my suspension overhaul. I have the ST bars off of my car now and ready to go. If you want to do the trade, I need you to be certain of what you have, and I recommend measuring the bars in a few locations with calipers if you aren't sure (because I WILL bring calipers with me if we meet up). This is a great deal for anyone looking to beef up their sway bars since this setup is $360 at Turner and all I want in exchange are your two stock bars, no links or other stuff.
My bars are in fine condition. The front is a bit scraped on the bottom from a decade of driveways and road debris, but it is just surface scratches. Do be aware that I HIGHLY recommend reinforcing all 4 rear mount points. The trailing arms should have reinforcing plates welded on because they will see a lot more stress, and you really really really should look into a Turner or AKG reinforcement bracket for the chassis mount points (the ones that bolt in through the trunk are fine). I had a chassis mount point rip out on me a few years back and I had to weld it back on. I am not including reinforcement brackets in this trade.
So, PM me if you are in the SF Bay Area (I am down in Santa Clara) and think you can have the parts I want by Friday. I know that this is last minute and oddly specific, but it is what it is.
Comment