hello.
first of all. These are my rear numbers. :-?
Woops. by jet jones, on Flickr
what i have in the rear is 9mm subframe raiser bushing
and ie camber/toe adjusters.
They were on ie3 springs so it was very low.
the camber/toe was adjusted accordingly and was within spec.
my diff. support broke so i had to weld in a new one. you can read it here.https://www.r3vlimited.com/board/sho...d.php?t=424536
but i couldn't really figure out how exactly to find the correct diff. angle
to weld the cover brackets. i believe it to be alittle high. or not. Would that really throw it off this much?
I now have 17s so a good amount of height was added via coil-overs.
Is it that high up to be giving those numbers?
So, right now I don't know what to do really....
Toe-in is completely maxed at this point.
Would using a normal, non-raised subframe bushing bring it back?
Thanks for the help. I'm really sorta stuck. Let me know if you need any measurements, or pictures. anything...
Here it is as it sits.
It's a little high, but like iI said, don't think it's high enough to effect camber/toe perhaps maybe or not.
Enjoying the e30 by jet jones, on Flickr
first of all. These are my rear numbers. :-?
Woops. by jet jones, on Flickr
what i have in the rear is 9mm subframe raiser bushing
and ie camber/toe adjusters.
They were on ie3 springs so it was very low.
the camber/toe was adjusted accordingly and was within spec.
my diff. support broke so i had to weld in a new one. you can read it here.https://www.r3vlimited.com/board/sho...d.php?t=424536
but i couldn't really figure out how exactly to find the correct diff. angle
to weld the cover brackets. i believe it to be alittle high. or not. Would that really throw it off this much?
I now have 17s so a good amount of height was added via coil-overs.
Is it that high up to be giving those numbers?
So, right now I don't know what to do really....
Toe-in is completely maxed at this point.
Would using a normal, non-raised subframe bushing bring it back?
Thanks for the help. I'm really sorta stuck. Let me know if you need any measurements, or pictures. anything...
Here it is as it sits.
It's a little high, but like iI said, don't think it's high enough to effect camber/toe perhaps maybe or not.
Enjoying the e30 by jet jones, on Flickr
Comment