So I installed the camber and toe adjusters and then installed the subframe. Then I installed the controls arms to only realize that getting to the toe nuts was simply impossible. So I lowered the subframe and installed the the control arms. But I had to keep the subframe down a couple inches because gaining access to the nuts is impossible once the subframe is up. Not an issue on my other stock 1989 325i but the adjusters pushed them out a little to far.
So is the only way to tighten them to lower the subframe???? I can see adjusting toe to be a rather lengthy process once the entire car is back together.
Thanks,
Jason
So is the only way to tighten them to lower the subframe???? I can see adjusting toe to be a rather lengthy process once the entire car is back together.
Thanks,
Jason
Comment