FS:Shifter Carrier Bushings

[bradnic]

I'll buy 2 sets when you the fronts in stock. please PM when you're ready

[brent5631]

Bippity boppity BUMP!

[rturbo 930]

Quick question, how tightly do the front bushings fit in the carrier?

[brent5631]

Thanks for the couple orders. They will be out tomorrow.

Quick question, how tightly do the front bushings fit in the carrier?

You can push them in by hand maybe a little tighter on some though. Also the carrier is cast so exact fitment is hard to tell on every one. It's designed to have no slop at all.

[dvck]

Lmk when you have the fronts as well I'd like a complete set

[r4esh]

^ What he said.

[brent5631]

Ok. Well I guess I'll make a few sets this weekend.

[Regnar75]

pay pal sent for 1 rear

[rturbo 930]

You can push them in by hand maybe a little tighter on some though. Also the carrier is cast so exact fitment is hard to tell on every one. It's designed to have no slop at all.

Good to know, thanks. That's interesting, since the UUC bushings I got just fall right out. I don't think they're actually an improvement over stock. They accidentally sent me two sets, and BOTH of them were loose. Not only are they loose in the carrier, the bitch clip/pin has a bit of play when installed, as well.

I'll likely buy a full set from you.

[Balleristic31]

Love these. My only problem was that I didn't put grease on the rear bushing and it squeaks :/ gotta get on that

[rhE-30]

Can you send a pm when you have a full set avilable?

[brent5631]

Good to know, thanks. That's interesting, since the UUC bushings I got just fall right out. I don't think they're actually an improvement over stock. They accidentally sent me two sets, and BOTH of them were loose. Not only are they loose in the carrier, the bitch clip/pin has a bit of play when installed, as well.

I'll likely buy a full set from you.

That's weird. I have similar dimensions to the Uuc bushings so I wonder if your carrier is slightly larger.





Also since there seems to be some interest I'll make a small run of fronts bushings this weekend and post in here again.

[rturbo 930]

That's weird. I have similar dimensions to the Uuc bushings so I wonder if your carrier is slightly larger.

That's odd, but it would explain why two different sets don't fit properly. I just measured my spare set and the OD came out to be 0.658".

[brent5631]

Since you have a caliper, if you could measure the actual shifter arm I can make yours slightly larger no charge. I'll be cutting them tomorrow night.

[RUFFLZ]

Lace me up with a rear bushing if you have any left.