How much would it be for the complete rear kit only? Already have e36 m3 front hubs
Announcement
Collapse
No announcement yet.
FS: 5-lug Kit | E36 & E46 Hub & Caliper Adapters for E30! | Rear Big Brake Kit
Collapse
X
-
pm'd[ETA - E30 Adapters] 5 Lug kit with e46m3 front and e46 325/328i rear brake setup
---------------------------------------------------------------
[ETA - E30 Adapters] - 5 Lug kit | DTM Shifter | DSSR
---------------------------------------------------------------
Transaction Feedback
Comment
-
Originally posted by Max399 View PostYes, but as you can see the 300mm.de rear adapters are not raised:
They are flat, where as the ones i offer are raised:
They move the calipers towards the rotor.
How much is your adapter raised? If 5mm, then it sounds like you offer the same product at half the price. The solution is z4 2.5 rotors and e36 m3 brakes. For those of us who have e36 m3 front end, this would be the ideal setup.
Comment
-
Originally posted by MyE30 View PostIt's probably been asked but are there any plans to make rear brackets to fit e36 m3 rear calipers on e30 m3 trailing arms?
It's very expensive, so I'm thinking the rear adapters here, at $140 shipped, might do the job if their added width is 5mm.
Comment
-
Originally posted by MyE30 View PostIt's probably been asked but are there any plans to make rear brackets to fit e36 m3 rear calipers on e30 m3 trailing arms?
Originally posted by TSI View PostThis is basically what I'm looking for in the post above. The E30 m and non-m trailing arms are the same, the only difference is the hub, which is 5 lug and sticks out 5mm more on the M3. (the bearing is the same too) 300mm.de offers a solution to run them: http://300mm.de/294mm/294adapter.html
It's very expensive, so I'm thinking the rear adapters here, at $140 shipped, might do the job if their added width is 5mm.
Max.
Comment
-
Originally posted by Max399 View PostAs far as i am aware, there are no plans like that.
Hm, i see what you mean, i will tomorrow, on Monday and reply about how much it is raised.
Max.
Any luck?
You may be also able to use E36 ti brackets as adapters, as per here: http://www.r3vlimited.com/board/show...=1#post4197322 but I don't know how that works
Comment
-
Originally posted by Max399 View PostYes, unfortunately not..
Max.
On a more general basis, the rear adapters that you sell--do they require the use of an E30 M3, E36ti, Z3 or Z4 rear hub for proper fitment? I think I may be able to figure out a way of getting the E36M3 brakes on there.
Comment
Comment