m20 CP Pistons :Sachs m52 clutch kit :Rebuilt eta injectors

[nyChris]

All items are brand new, and have never been installed. Shoot me a pm, or leave a comment with any questions.

--------------------------------------------------------------------

CP Pistons - m20 - 85mm bore - 8.5:1 compression ratio
$875.00 shipped

These pistons are designed for 135mm rods, and an 81mm stroke (m20b27) crank.

Arguably the best pistons for your 2.7i turbo build.







--------------------------------------------------------------------

Sachs Clutch Disk + Pressure Plate - Fits m52 dual mass flywheel
$200 shipped





--------------------------------------------------------------------

Rebuilt ETA Fuel Injectors
ultrasonically cleaned and flow tested
$30 shipped



--------------------------------------------------------------------
MegaSquirt-III with MS3X Expansion V3.57 + Harnesses - Assembled by DIYAutotune
SOLD $625 Shipped

MapDaddy 4 bar map sensor with Barometric correction
SOLD $50 Shipped

Innovate LC-1 Controller + O2 Sensor
SOLD $100 Shipped

Spec Stage 2 m20 Clutch Disk + Pressure Plate (p/n SB102)
SOLD $300 shipped

Lemforder Tie Rod Ends - e30
SOLD $50 shipped

Revshift 95a Poly Diff Bushing - e30
SOLD $35 shipped

[Kershaw]

Where were you 2 weeks ago? Haha. Nice prices.

[dzverko]

Interested in the LC-1! Does it come with the gauge or no?

[nyChris]

Innovate, and MapDaddy pending sale.

Interested in the LC-1! Does it come with the gauge or no?

No gauge. Just the controller and sensor.

[nyChris]

Innovate, and MapDaddy sold.

[trippmann]

MS comes with a wiring diagram?! I've been putting off collecting parts because the wiring scared me! Free bump.

[nyChris]

MS and CP's still available.

MS comes with a wiring diagram?! I've been putting off collecting parts because the wiring scared me! Free bump.

MS is pretty well documented. Still a bit of wiring to figure out on your own, but nothing you would need an EE degree to understand.

[5Toes]

more specs on megasquirt? please pm me. I could pick it up end of the month

[nyChris]

more specs on megasquirt? please pm me. I could pick it up end of the month

Its the standard MS3X assembled by DIYAutotune. Both the Harnesses for the main, and expansion board are included.

[eThirtyAaron]

So those Pistons won't work with a b25 crank?

Sent from my SAMSUNG-SM-G928A using Tapatalk

[nyChris]

So those Pistons won't work with a b25 crank?

Sent from my SAMSUNG-SM-G928A using Tapatalk

The pistons are designed to be used with an eta crank, "e" or "i" block bored to 85mm, and an 885 cylinder head.

[ElijahKnapp]

So the pistons are for ETA crank with ETA rods? Do they have piston rings included?

[nyChris]

So the pistons are for ETA crank with ETA rods? Do they have piston rings included?

No, ETA rods are 130mm. 135mm rods are found in a number of BMW engines including the m20b25 "i" engine.

This is what your engine would consist of:

• m20 block (cylinders bored to 85mm)
• 81mm crank (cast "ETA", or forged diesel)
• 135mm rods ("i", s52, etc.)
• 885 head
• stock "i' or aftermarket cams (valve relief depth is listed on the spec sheet)

[nyChris]

bump

[nyChris]

weekend bump