If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
it doesn't fit in my engine bay, do I need to trim it? it's way too long and abs prongs scratch it.
Same problem... No way it fits wit the stock AFM.
If you have an M20B27, you would need to somehow cut down 2"-3" off the total length of the intake from the end of the intake elbow boot to the end of the carbon fiber enclosure.
If you have an M20B27, you would need to somehow cut down 2"-3" off the total length of the intake from the end of the intake elbow boot to the end of the carbon fiber enclosure.
If you have an M20B27, you would need to somehow cut down 2"-3" off the total length of the intake from the end of the intake elbow boot to the end of the carbon fiber enclosure.
Before i did my I head build I never had to cut or modify anything when on the stock eta stuff, gotta be a little creative with that bracket but other than that it fitted fine, even with the rear headlight cover, however though this was when I was one of the first people to run his intake system so idk if the dimensions has changed over time
Before i did my I head build I never had to cut or modify anything when on the stock eta stuff, gotta be a little creative with that bracket but other than that it fitted fine, even with the rear headlight cover, however though this was when I was one of the first people to run his intake system so idk if the dimensions has changed over time
Kameron has a facebook page try reaching him there
Circle A is the top of the ABS. Circle B is the line coming out of the radiator towards the firewall and down.
I can't close the hood with the filter bolted up because it sits atop the ABS. I can't divert it to the right side like I see in all the photos because the side of the filter meets that line from the radiator.
Comment