Can't Twist the Shift Selector 10 degrees

[SwiftE30]

If graphikg doesn't want/need it, I'll let you know. :up:

thanks

[graphikg]

Hey anderson - DEAL...! I will take it. Bought from you before and will do it again with pleasure. PM me your paypal again with price. I actually might have your paypal.

[toointoxicated60]

table vice + adjustable wrench

[dashboardmonkey]

i used oxy/acetylene torch, like warm butter

[ian e30 318is]

Buy a DSSR...cut and reweld

[graphikg]

I just went to an autoshop and they let me borrow their vice.

[lolcantturn]

I cut the selector rod about 3/4ths of the way through, twisted it fairly easy, and welded it.

[singh336]

pics of these installed after the twist/bending ?

[graphikg]

Should be right in the middle, but I guess I will just snap a quick pic.

[tonytony]

um.....this isn't that hard to do at all. put two deep sockets on the studs and bend till you get to 10 degrees(give or take). you're bending the studs not "twisting" the selector rod.

[El Gato Liso]

lol...

when i did this, i literally took each end of the selector and put it into the ring part of 2 spanners. it twisted with no effort. piece of cake!

:hitler:

[e30shmobberr]

you need a vise and leverage