Those are oem. Im running them with no issues.
Josh if you to barrow parts lmk
My m50 is pinging. Running out of ideas.
Collapse
X
-
Go get the NGK plugs. That was the other half of my issue. Never ran right with the Bosch plugs.Leave a comment:
-
I would just do them all, just so you know. My old m50 ran like shit and got terrible mileage, so I replaced the blue coolant temp sensor and it woke it right up and got my mileage back.Leave a comment:
-
02 has 50k and the coolent temp has 13x,xxx. Might still replace all of them just to be sure.Leave a comment:
-
My motor has about 130k and I don't typically need to add oil between changes.
The e34 has 109 and I may add 1/4 of a quart between changes.Leave a comment:
-
I agree 100%, but changing fuel and it making a difference is a dead giveaway.if its at low as 20% load i doubt its a lean AFR thing. you should be able to lean if off to point of missfire at low load on a low VE NA motor. IMO there is something in there that when combined with the 60C IAT are causing an issue. check plugs for heavy buildup put them back in, Seafoam it and then add new plugs (non fancy ones) after seafoaming and driving all the depsoits out.
I will also say that every BMW I have dyno'd, starting with the stock file, they always run extremely lean until 3000rpm or so, m20 and 24v alike. When I say lean, it's well into the 15's. If they don't ping on the dyno at WOT, find it difficult to believe it is ping with light throttle, and why my first hunch was vanos rattle.Leave a comment:
-
I have been running 91 in both of my m50 cars. I used to run 89 without any problems either but have been using 91 for a few years now.
Going to be tearing into the e34 tomorrow. Smoke test, knock sensors, intake gaskets, fuel filter, and air filter.Leave a comment:
-
if its at low as 20% load i doubt its a lean AFR thing. you should be able to lean if off to point of missfire at low load on a low VE NA motor. IMO there is something in there that when combined with the 60C IAT are causing an issue. check plugs for heavy buildup put them back in, Seafoam it and then add new plugs (non fancy ones) after seafoaming and driving all the depsoits out.Last edited by digger; 06-05-2014, 03:48 PM.Leave a comment:
-
Have you tried using better fuel and noting the difference? My Ford v10 has a light rattle under light throttle and on the highway if I use 87 octane (specially when hauling) and doesn't if I use 91 or better (my old F150 4.6 did the same thing) once they started getting high in miles. This will at least give you an idea if it is in fact pre-detonation since it will lighten up with better fuel. If no change it may be something else.Leave a comment:
-


Leave a comment: